What are the methods of using the high voltage wireless nuclear phase meter?

Instructions:

The high-voltage wireless nuclear phase analyzer can hear the sound signal when it touches the live wire and four indicators light up. After 5-10 seconds, the LED2-4 will be off and the sound signal will stop. The working time set when the transmitter is used as the voltage measurement is 5- After 10 seconds, the phase measurement is automatically entered. At this time, only one LED indicator is on. If the sound and light signals do not stop after 5-10 seconds, that is, the battery power is low, the battery must be replaced. If you want to measure the other phase of the line, you need to take the transmitter off the line until the LED1 goes out and put the transmitter on the line to do another voltage measurement. Ibid.

When entering the measurement mode, the transmitter transmits radio frequency signals to the air while a part of the signal is transmitted along the line as an antenna. Once the receiver can recognize the signal, the receiver immediately starts operation.

The high-voltage wireless nuclear phase analyzer is a special-purpose device used for checking the phase sequence of large-scale equipment such as high-voltage power lines and transformers before installation and operation. Changing the contact-type measurement method in the past, eradicating the dangers of contact-type measurement has ensured the personal safety of the measurement personnel. The measurement method is simple and the measurement results are reliable.

Instrument features:

Screen display content: wireless high-voltage nuclear phase meter, different phases, in-phase, X, Y,

Power Source: One battery (NEDA/604/6F22) or equivalent. X and Y collectors 5 AG13 batteries.

Automatic shutdown: The host automatically shuts down about 15 minutes after turning on the computer.

Backlight Source: During the phase detection process, if the light is too dark, making it difficult to read the data, you can press the backlight switch.

Technical Parameters:

Voltage level: 0.38kv to 220kv

Host power supply: 9V ±2V

Collector power supply: 7.5V ±1.5V

The transmission distance between the host and X, Y collectors is: X≥80m Y≥50m

Working environment: -35°C～+50°C Humidity: ≤95%RH

  Storage environment: -40°C～+55°C Humidity: ≤95%RH

Insulation telescopic rod: shrink state 600mm stretch state 3200mm

Packing box size (length × width × height): 650mm × 250mm × 100mm

High-voltage wireless nuclear phase meter product weight: 5kg