Switch socket installation order
1, first find the switch socket in the specific location of the drawings, the floor looks a bit like the English "F".
2, with the socket box prepared in advance to draw a rough frame, this tool is helpful for positioning neatly.
3, measuring the vertical direction of the wire pipe walking distance from the wall.
4, in the corner measured the same width position.
5, according to the location of the point just measured can draw two vertical lines drawn.
6, cutting machine along the line to cut.
7, drill appearance, out of a suitable pipe slot, the depth of the groove and the diameter of the pipe match, the pipe can be condemned, and open neat to reflect the level of a construction team and experience.
8, open a box hole, and embed a connector from inside the box.
9, do a good job box, it will be embedded in a good wall.
10, count the distance from the box to the ground pipe to ensure smooth bending, the pipe is not broken.
11, the pipe and the box connected, just at the bend on the ground.
12, the new pipe threading can not be used to wire, but if you wear expensive acoustic line or long-distance threading more standardized approach to use the wire.
13, the first wire hit a hook to prevent sharp scratches inside the pipe.
14, the wire slowly inserted into the pipe, slowly promote, to avoid too fast and lead to scratches inside the pipe.
15, the wire out from the other end, and the wire together, slowly pull the wire into the pipe, the wire is actually the lead in the process.
16, the wire to the box, the pipe connected with the matching connector.
17, as a hidden project, the interface must be closed, no damage.
18, the other end of the wire to promptly use the pressure cap to protect.
19, the first part of the normative approach is all hidden in the box, but the control of the length of the thread is a matter of detail, a lot more can be regarded as norms.
20, threaded part of the completion of the measurement circuit is unobstructed after a series of acceptance can be filled with cement flat.
21, the ceiling wire threading process is basically the case, but generally due to the ceiling to go is the lamp line, so just wear a red hot line and blue zero line.
Hydraulic Fittings and adapters are components used in hydraulic systems to connect hoses, pipes, and other hydraulic components together. They provide a secure and leak-free connection between components, allowing the hydraulic system to function properly.
Hydraulic fittings are typically used to connect hoses or pipes to other components, such as pumps, valves, cylinders, and filters. There are many different types of hydraulic fittings available, including:
O-ring fittings: These fittings use a compressible O-ring to create a seal between the fitting and the component it is connecting to.
Flared fittings: These fittings use a cone-shaped sleeve and nut to compress the end of a pipe or hose against a fitting, creating a seal.
Compression fittings: These fittings use a ferrule to compress a pipe or hose against a fitting, creating a seal.
Hydraulic adapters, on the other hand, are used to connect two different types of hydraulic fittings together. For example, an adapter might be used to connect a hose with a male O-ring fitting to a component with a female flare fitting. Adapters come in a variety of configurations, including straight, 45-degree, and 90-degree angles.
Choosing the right hydraulic fitting or adapter for your hydraulic system is crucial to ensuring a leak-free connection and proper system function. It's important to consider factors such as the type of fluid being used, the pressure and temperature of the system, and the compatibility of the fittings with other components in the system.
Oem Hydraulic Fittings And Adapters Quotes,Hydraulic Adapters Fittings Suppliers,Hydraulic Adapters Fittings,Wholesale Hydraulic Adapters Fittings,Hydraulic Adapters Fittings Factory
Zhejiang Hanying Technology Co., Ltd. , https://www.hydraulicfactory.com