Can a poe switch be connected to a non-poe device?

2020-02-11 17:05:24
Many friends have asked if the device is not a peo device and can use a poe switch?
The answer is yes!

Before the power supply, there is a function of detecting and identifying. When the device is connected, the PoE switch sends a signal to the network to detect whether the IP terminal in the network has a PoE-supported device. If it is supported, the PoE switch will give it. Power supply, if it does not support PoE switch, it will not supply power. This has a protective effect on the IP terminal to prevent burning of the device.
The non-standard PoE switch does not have a PoE control chip inside, and directly transfers power through the idle line pairs 45 and 78 in the network cable. This step is not detected. Regardless of whether the IP terminal supports PoE, it will supply power to it. If the IP terminal does not support PoE power supply, it is likely to burn the network port, that is, burn out the device.
Although non-standard PoE switches are incomparable with standard PoE switches, there are still some non-standard PoE switches on the market. Mainly because non-standard work is simple, there is not much technical content, and the cost is relatively cheap.

Note: Standard POE switches can be directly connected to non-POE devices. Non-standard POEs cannot be accessed. For non-standard access, terminals need to add POE splitters.

Air-Fluid Male Swivel Elbow - Male Thread BSPT


Cixi Air-Fluid Company 'BSPP Thread Metal Pneumatic Push In Fittings with below characteristics:


BSPP Thread Introductions : The British Standard Pipe Parallel (BSPP Threads )have the same diameter from end to end ,A parallel thread typically seals with use of an o-ring or Back Washer to seal the fittings ,no use of Anaerobe. The sealing ring (O-ring) can be easily replaced if it is damaged or hard-worn with time. Connection and disconnection of the tube can be repeated and can be performed using one hand , no other tools required .


Thread Connection : Range from BSPP 1/8" to 1/2"

Push-in Connection: Range from Inch Size 5/32" to 1/2" OD & Metric Size 04mm to 16MM

Configurations Includes: Straight , Elbow , Branch Tee ,Run Tee, Long Leg Male Elbow and Speed Control Valve .





Metal Pneumatic Push In Fittings BSPP

Metal Pneumatic Push In Fittings BSPP, Pneumatic Push In Fittings, Metal Pneumatic Fittings

Ningbo Air-Fluid Pneumatic Components Co., Ltd , http://www.air-fittings.com