Installation quality affects the use of auxiliary lighting fixtures to install five steps
2024-10-05 17:00:26
The quality of the installation has a very important influence on the use of the auxiliary luminaire. In general, auxiliary lighting fixtures need to be installed in a professional modification store. First of all, the car mainly selects the corresponding number of auxiliary lighting fixtures according to the load capacity of the generator of the own vehicle, so as to avoid the shortage of power supply of the generator caused by the excessive total power of the auxiliary lighting fixture. Second, choose a reasonable installation location. Auxiliary lamps vary in function depending on the function. Some lights can be installed on the roof and some must be installed on the front of the front. In the case of a fog lamp, if it is installed on the roof of the car, it may cause reflection on the windshield or the engine compartment cover, and the spotlight generally does not have such a nighttime illumination effect. Third, auxiliary lighting fixtures should use separate power lines and add independent insurance. Auxiliary lamps cannot share the power supply line with the original car lamps, otherwise the line will be overloaded. When installing, be sure to lay a separate line for the auxiliary luminaire that can withstand its working current, waterproof, dustproof and insulation protection, and increase the corresponding insurance. Fourth, the switch circuit of the auxiliary lighting fixture must be equipped with a relay to achieve weak current control and strong power to ensure safety. At the same time, it is better to provide the switching power supply of the auxiliary lighting fixture by the original vehicle width lamp circuit, to ensure that the auxiliary lamp is extinguished with the original lamp being extinguished, and the battery is not over-discharged due to forgetting to close. Fifth, when installing auxiliary lighting fixtures, be sure to check if the grounding is good. When installing auxiliary lighting fixtures, the body grounding is generally adopted. When selecting the grounding point of the vehicle body, it is necessary to pay attention to the influence of the surface paint on the grounding. If the grounding is poor, it will not only affect the brightness, but also cause safety hazards. Finally, it is best to use a plug-type connection between the luminaire and the wire to facilitate the detachment of the luminaire when maintenance is required.
brass Press Fittings according to vigea and connex quality,approved kitemark and DVGW,Brass Press Fittings,brass press fittings,press Brass Fittings,pipe press fittings, V type brass press fittings,M type brass press fittings,M type brass press fittings Brass M type adapter press fitting Lead Free Brass Press Fittings 1/2"-2"
Brass Press Fittings,brass press fittings,press brass fittings,pipe press fittings, V type brass press fittings,M type brass press fittings
Taizhou Runde Company , https://www.zjcopperfittings.com