Self-repair of sprinkler faults
Sprinklers are the common special vehicles in the city and have made important contributions to the city's environment. How should the sprinklers respond to the following failures? Below we introduce some specific methods.
1. When there is a leak in the cylinder head of the sprinkler truck , leakage and leakage occur.
At this time, we can use some special electric fuses according to the size of the loopholes, and then pry them into the leaks properly with a hammer so that we can eliminate oil leakage and water leakage.
2. When the fan belt breaks
At this time, the broken belt can be tied up with iron wire, or the car can be driven off using the method of opening and stopping.
3. When the tubing breaks
When a tubing breaks, we can connect it with a tubing of the same length as the tubing. However, if the connection does not work, the two ends are then tied tight with iron wire so that oil leakage can be prevented. 4. When the fuel tank is damaged
If the motor vehicle is in use and there is a case of oil leakage from the fuel tank, it should be cleaned up in a timely manner or coated with a viscous material such as bubble gum in the oil spill so that it can temporarily block, if further repairs, Then you can use epoxy resin adhesive repair, repair better.
5. When the inlet and outlet hoses break
When the breakage is not large, we can use some fabrics and other materials to tie the leaking places. However, if the breakage is serious, we should use iron pipes or bamboo pipes to remedy the situation. .
6. When the screw hole is slipped
The sprinkler will stop working when the screw hole is slipped, and it will cause oil leakage when it is serious. How should we solve this? We can use a hammer to flatten the slide bar and then fix it, but it should be noted that it cannot be dismantled many times. If the malfunction is serious, it should be repaired during the next maintenance.
7. When the tubing ruptures and leaks
When the tubing leaks, first remove the excess oil with a clean cloth or paper, then apply some soap on the cracked area, wrap it around the cracked area with a strong cloth or tape, and finally tie it tightly with wire. Finally, apply some soap to prevent oil leakage.
Plastic Pipe Vacuum Calibration Tank
The Molten Extrudate in The Extruder Is Drawn into The First Vacuum Chamber Through Calibration
The Vacuum Then Forces the Plastic Against the Calibration Tool While Cooling Its Surface Enough to Maintain Proper Dimensions. Cooling Water Enters the Chamber Through the Spray Bar.
The Calibrated Plastic Is Pulled Through a Second Vacuum Tank, Where It Is Cooled by Water Filling the Compartment. A Vacuum Can Be Applied to The Chamber to Help Maintain the Shape of The Plastic Product.
Depending On the Size of The Pipe, The Cooling System of The Vacuum Sizing Machine Can Be Cooled by Spray Cooling. Generally, Full Immersion Is Required When the Pipe Diameter Is Small, And Spray Cooling Is Appropriate When the Pipe Diameter Is Large.
After Cooling, The Plastic Product Passes Through the Final Chamber. The Rollers Help Guide the Plastic Through the Vacuum Setting Machine.
Plastic Vacuum Calibration Tank,Vacuum Tank,Plastic Pipe Calibrator
Zhangjiagang Polestar Machinery Co.,Ltd , https://www.polestarplast.com